Freescale Semiconductor Microcontrollers - Manual (Page 747)

Debugger Engine Commands
Debugger Commands
747 Microcontrollers Debugger Manual
Scrolls three positions down. The third line of registers is displayed on the top of
the register component.
in>Register < ATTRIBUTES VSCROLLPOS 0
Returns to the default display. The first line of registers is displayed on the top of
the register component.
in>DEFINE vpos = 5
in>Register < ATTRIBUTES HSCROLLPOS vpos
Scrolls five positions right. The second column of registers is displayed on the left
of the register component.
in>Register < ATTRIBUTES HSCROLLPOS 0
Returns to the default display. The first column of registers is displayed on the left
of the register component.
in>Register < ATTRIBUTES COMPLEMENT One
Sets the first complement display option. All registers are displayed in reverse bit.
In the Source Component
The ATTRIBUTES command allows you to set the display and state options of
the Source component window. The SMEM (show memory range) command and
SPC (show PC address) command loads the corresponding module’s source text,
scrolls to the corresponding text range location or text address location and
highlights the corresponding statements. The SMOD (show module) command
loads the corresponding module’s source text. If the module is not found, a
message is displayed in the
Component Windows Object Info Bar . The SPROC
(show procedure) command loads the corresponding module’s source text, scrolls
to the corresponding procedure and highlights the statement, that is in the
procedure chain of this procedure. The numberAssociatedToProcedure is the
level of the procedure in the procedure chain. The MARKS command (ON or
OFF) displays or hides the marks.
NOTE Also refer to SMEM SPC , SPROC and SMOD command descriptions for more
detail about these commands.
Equivalent Operations
• ATTRIBUTES SPC ~ Drag and drop from Register component to Source
component.
• ATTRIBUTES SMEM ~ Drag and drop from Memory component to Source
component.