Freescale Semiconductor Microcontrollers - Manual (Page 434)

HCS08 Full Chip Simulation
Configuration Procedure
434 Microcontrollers Debugger Manual
initialization does not apply to a reset command. When you change this option, the new
state takes effect the next time you start HiWave (or switch Device Mode/Debug Target).
View Register Files Command
The View Register Files selection in the HCS08FCS menu also gives the user the option of
running the register file viewer/editor. If register files are available for the device that you
have chosen, the Choose a Register Block window (see
Figure 18.4 ) opens. You may
also open it by entering the R command in the Command Window command line.
Figure 18.4 Choose A Register Block Dialog Box
If register files have been installed on the host computer, selecting a block brings up the
Register Block register listing (see
Figure 18.5 ), which shows a list of the files, their
addresses, and their descriptions. This begins interactive setup of system registers such as
I/O, timer, and COP watchdog.
Figure 18.5 Timer Interface Module Register Listing
Selecting a file brings up the Register Window (see Figure 18.6 ), which displays the
values and significance for each bit in the register. The registers can be viewed and their
values modified, and the values can be stored back into debugger memory.