Freescale Semiconductor Microcontrollers - Manual (Page 557)

RS08 P&E Multilink/Cyclone Pro Connection
Connection Procedure
557 Microcontrollers Debugger Manual
Prompt on Flash Program Checkbox
Checking Always Erase and Program Flash without asking in this dialog box lets the
software transparently program the microprocessor.
Trim Programming Checkbox
The Trim Programming checkbox enables automatic calculation and programming of
the trim value in a designated non-volatile memory location.
Sync to PLL Change Checkbox
Sync to PLL Change is required for the software/hardware connection to synchronize
with the microprocessor during the Flash erasing/programming procedure.
Start Expert Mode Programmer Option
The Start Expert Mode Programmer option in the Connection Menu grants the user access
to P&E’s graphical Flash programming utility, PROGRS08. PROGRS08 lets an advanced
user control the step-by-step execution of the Flash erase/programming procedure. See
Figure 25.8 . More information on how to use the PROGRS08 can be found on the P&E
Microcomputer Systems website at www.pemicro.com.
Figure 25.8 PROGRS08 Programmer Window