Freescale Semiconductor Microcontrollers - Manual (Page 700)

Flash Programming
Automated Application Programming
700 Microcontrollers Debugger Manual
Figure 32.1 Flash Programming Acceptance Dialog Box
Select the OK button to launch background Flash commands. These commands arm
programming, load/program an application file, then disarm programming, and are
described later in this chapter.
Check the Do not display this message anymore for this project checkbox to remove
the Warning message for the current project. The setting is saved in the project under the
project variable: AEFWarningdialog box=FALSE.
Setup
Choose the Load menu entry in the connection debugger menu (for example, HCS08
Open Source BDM) to open the Load Executable File dialog box.
Figure 32.2 Load Executable File Dialog Box option
Check the above option to automatically mass erase the device and program the
application into non-volatile memory (FLASH and/or EEPROM).
To permanently set this option, a check box is available in the Load tab of the debugger
Preferences dialog box, as shown in
Figure 32.3 . Select the File > Configuration menu
command to display this dialog box.
Figure 32.3 Load Preferences