Freescale Semiconductor Microcontrollers - Manual (Page 31)

Debugger Interface
Starting the Debugger
31 Microcontrollers Debugger Manual
-Nodefaults
This prevents the debugger from loading the default layout. For example:
c:\Program Files\Freescale\CodeWarrior for Microcontrollers
V6.1\prog\hiwave.exe -nodefaults
-Cmd = <Command>
This option specifies a command to be executed at start-up: -cmd = {command}. For
example:
c:\Program Files\Freescale\CodeWarrior for Microcontrollers
V6.1\prog\hiwave.exe -cmd="open recorder"
-C <cmdFile>
This option specifies a command file to be executed at start-up. For example:
c:\Program Files\Freescale\CodeWarrior for Microcontrollers
V6.1\prog\hiwave.exe -c c:\temp\mycommandfile.txt
-ENVpath: "-Env" <Environment Variable> "=" <Variable
Setting>
This option sets an environment variable. This environment variable may be used to
overwrite system environment variables. For example:
c:\Program Files\Freescale\CodeWarrior for Microcontrollers
V6.1\prog\hiwave.exe -EnvOBJPATH=c:\sources\obj
NOTE Options are not case sensitive.
Order of Commands
Commands specified by options are executed in the following order:
1. Load (activate) the project file (see below). If the project file is not specified,
project.ini is used by default.
2. Load <exeFile> if available and start running unless option |(W) was specified
3. Execute command file <cmdFile> if specified
4. Execute command if specified
5. Start running unless option |(W) was specified
NOTE In version 6.1 of the debugger, the loaded program starts after all command and
command files are executed.