Freescale Semiconductor Microcontrollers - Manual (Page 343)

MON08 Interface Connection
Connection Procedure
343 Microcontrollers Debugger Manual
Advanced Programming/Debug Options
The Advanced Programming/Debug Options menu entry takes you to the Advanced
Options dialog box, where you can configure the software settings for the Flash
programming procedure.
Figure 12.10 Advanced Options Dialog Box
Prompt on Flash Program Checkbox
Checking Always Erase and Program Flash without asking lets the software
transparently program the microprocessor.
Trim Options
The Calculate Trim and Program the Non-Volatile Trim Register checkbox enables
automatic calculation and programming of the trim value in a designated Non-Volatile
memory location.
Sync to PLL Change Checkbox
Sync to PLL Change is required for the software/hardware connection to synchronize
with the microprocessor during the Flash erasing/programming procedure.