Freescale Semiconductor Microcontrollers - Manual (Page 477)

477 Microcontrollers Debugger Manual
20
HCS08 Open Source BDM
Connection
This chapter guides you through the first steps toward debugging with the CodeWarrior
IDE and the HCS08 Open Source BDM connection. It does not replace all the additional
documentation provided in this manual, but gives you a good starting point.
HCS08 Open Source BDM Technical
Considerations
The 8/16 bits debugger (and then the CodeWarrior IDE) can be connected to HCS08
hardware using the HCS08 OSBDM (Open Source BDM) cable.
When the debugger runs the HCS08 Open Source BDM connection, it can communicate
and debug HCS08 core-based hardware connected through the Open Source BDM
Interface as described at the Freescale Semiconductor web site:
http://www.freescale.com
(keyword: OSBDM08).
CodeWarrior IDE and HCS08 Open Source
BDM Connection
There are two separate paths that may be followed to take the first steps toward debugging
with the CodeWarrior IDE and the HCS08 Open Source BDM connection. The
differences between the two paths hinge on the starting point for the steps:
• Using the Stationary Wizard at the start of the project
• From within an existing project