Freescale Semiconductor Microcontrollers User Manual
Page 406
HC08 FSICEBASE Emulator
Setting Up the FSICEBASE System
406
Microcontrollers Debugger Manual
c. Connect other end of USB cable to host computer
NOTE
The host computer (PC) must have an assigned IP address and subnet mask that
matches the FSICEBASE.
3. If you are using a USB connection to connect your host computer directly to the
FSICEBASE:
a. Make sure power supply is not connected to board
b. Connect U-shaped end of USB cable to FSICEBASE
c. Connect other end of USB cable to host computer
Once you have connected the host computer to the FSCIBASE, connect Power supply to
FSICEBASE
1. Connect round end of 5-volt power cord to barrel connector on FSICEBASE
2. Plug power supply into surge-protected strip
3. Connect surge-protected strip to AC outlet
4. Switch FSICEBASE Power switch to ON
LED lights after the base station finishes boot sequence.
There are three status LEDs on the box: busy, ready, and error. The FSICEBASE base
station takes about 5 seconds to boot. After powering the unit, you must wait for the ready
LED before attempting to connect.
The FSICEBASE is now ready to accept communication with a host computer. Install the
CodeWarrior IDE software, create a project, and start the debugger to establish
communication between your host computer and the FSICEBASE.