Freescale Semiconductor Microcontrollers - Manual (Page 604)

ColdFire V1 Full Chip Simulation Connection
FCS Visualization Utilities
604 Microcontrollers Debugger Manual
Display Properties Dialog Box
This dialog box, shown in Figure 28.25 , allows you to modify the display properties from
the ADC/DAC component. The Up and Down buttons allow you to define the vertical
position of the input and output curves. Two control buttons allow you to change the axes
scales.
Figure 28.25 Display Properties Dialog Box
ADC/DAC Operations
To convert a signal from an example application:
1. Load the application and the ADC/DAC component.
2. Choose the ports address
3. Define the input signal frequency
4. Define the sampling frequency
5. Start the application
6. Choose Start Conversion
Drag Out:
Nothing can be dragged out.
Drag Into:
Nothing can be dragged in.