Yokogawa DAQWORX - Manual (Page 101)

3-23 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Using Data Monitor
3.6 Pausing and Terminating the Monitor
Pausing the Monitor
This operation pauses the display updating of the monitor. The measured data is
collected even when the display updating is paused. Therefore, when the display
updating is resumed, the data measured while the monitor was paused will be displayed.
Procedure
1. Click the “Pause” button on the toolbar or, from the menu bar, select “Monitor” then
“Pause.”
The display updating of the monitor stops.
Monitor pause button
2. To resume the display updating, click the “Pause” button on the toolbar again or,
from the menu bar, select “Monitor” then “Pause.”
Closing the Monitor Windows
The measured data is collected even when the monitor window is closed. Therefore,
when the monitor window is opened again, the data measured while the monitor window
was closed will be displayed.
Procedure
1. Click the “Close” button in the right upper corner of each monitor window.
The monitor window closes.
Note
To open the monitor window again, click the button of the monitor you wish to display on the
monitor bar.
Terminating the Data Monitor
When terminating the Data Monitor, if the monitor’s display conditions have been
changed, a dialog appears for you to specify whether or not to save the changes. Click
“Yes” or “No” as necessary.
Procedure
1. In the menu bar of the “DAQLOGGER Data Monitor” window, select “File” then
“Exit” or click the “Close” button in the upper right corner of the “DAQLOGGER Data
Monitor” window.
The Data Monitor terminates.