Yokogawa DAQWORX - Manual (Page 405)

7-229 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
Program Pattern Setting (Segment setting)
Set a program pattern for each segment, by clicking the [Program pattern] tab, then
selecting [Segment settings].
Select the pattern number
Select the segment number
Initialize the program pattern
Segment setting
Insert a segment before the selected segment
Add a segment behind the last segment
Delete the selected segment
Expand/reduce the selected segment along the time axis
Display the time axis per the segment time ratio
Display program patterns together
Split-display the program pattern at each loop
Turns the set point display ON/OFF
Select current loop (activates the
target value of the selected loop)
PV event display
Drag the bar
to change the
display area
Maximum value of
the span of the
current loop
Time event
display
Segment number
Target SP of the
selected segment
Duration of segment
Start value for selected segment
Minimum value of the span of the current loop
Drag the bar
to change the
display area
Select the Segment
Click the [Segment No.] arrow to select the desired segment in the program pattern
display screen.
Select Setpoints
Enter a program pattern for each segment.
Click this tab
Loop number
Start setpoint
(Set in [Default setting])
The target SP of the
previous segment for
subsequent segments
Select Ramp/Soak
Enter target setpoints
Enter the segment duration
Ramp-Rate Time Units
Slope
Segment PID group number
Segment shift action
Wait time
Wait zone number
7.10 Setting CX Series