Yokogawa DAQWORX - Manual (Page 35)

2-15 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Configuring the DAQLOGGER
Setting the Connected Recorder
Before you start this setting operation, obtain information about the recorders that are
connected: model, channels, options, communication address, etc.
If you are connecting to the recorder using the serial port, serial communication setting
must be completed in advance (see the previous section).
Procedure
From the “Recorder Setting” panel, assign the communication port and address to each
of the connected recorders.
1. To set the communication port, click the cell in the “Port” column and select from the
list box.
For example, when using Ethernet, COM1, and COM2, assign Ethernet, COM1, and
COM2 in the “Port” cells, respectively.
2. Click the cell in the “Address” column and set the recorder address of that port.
However, no address setting is needed for a port to which RS-232 is assigned.
Pressing the tool button at the bottom reassigns the address, starting from the
smallest address number, to the recorders in the selected range that are connected
via RS-422 in the order of the record numbers.
• For RS-422
The following dialog box appears. Set the items manually.
µR recorders: 1 to 16
VR recorders: 1 to 16
DX/CX DAQSTATION and MV MobileCorders : 1 to 32
(Excluding the DX1000/DX2000)
DARWIN: 1 to 31
DX1000/DX2000: 1 to 99
MV1000/MV2000: 1 to 99
2.6 Setting Communications and the Connected Recorder