Control channel settings (internal/external) – Yokogawa DAQWORX User Manual

Page 400

Advertising
background image

7-224

IM WX101-01E

Control Channel Settings (Internal/External)

The following settings apply to the internal and external loops’ SP, PV, and OUT

measurement displays.

To enter control channel settings, click the [Control(Int)] tab. Or, you can select the items

by choosing [Control Setting] - [SET [Basic] Setting] - [Control Channels (Internal)].

Tag

Enter a tag of using maximum of 16 characters.

You can enter a tag to be displayed on the screen instead of the channel number. Select

whether the channel name or tag is displayed in the [Setup] tab. By selecting [Tag] in [Aux]

of the [Setup] tab, you can select the tag No./tag comment or tag in the Data Monitor or

Data Viewer.

Zone

You can select the range on the CX’s screen where each channel waveform is displayed.

Set the lower and upper limits as percentages on the scale displayed.

The zone setting conditions are as follows:

• Setting range: 0 to 100%

Lower limit < Upper limit

• Difference between upper and lower limits: at least 5%

Graph
Div

Select the number of bar graph divisions from 4 to 12, or C10.

When selecting [C10], the scale of the trend display is divided in 10 major divisions,

numbered at the [0], [30], [50], [70], and [100]% marks.

Bar graph

Select the bar graph reference point. When the bar graph is displayed vertically, [Center]

is invalid, even if selected. During the data check it is changed back to [Normal].

Scale

When the scale is displayed in the trend display, select the scale display position.

For details, refer to the CX User’s Manual (IM 04L31A01-01E or IM 04L31A01-03E).

7.10 Setting CX Series

Advertising
This manual is related to the following products: