Yokogawa DAQWORX - Manual (Page 110)

4-9 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Using Historical V
iewer
Note
This dialog box shows the tag numbers of the tags that are set using the Tag Editor.
• Click the new tag name you wish to assign.
• If you do not wish to assign a tag, click the “None” at the bottom.
After the “Tag Name” dialog box is closed, the new settings will appear in the “General
Display Settings” dialog box.
5. Set the ON/OFF of the waveform display.
Click the check boxes in the “No.” cells for the tags you wish to display in the graph
to turn them ON (blue).
6. Set Y-axis display conditions.
Specify the ON/OFF of the Y-axis display when a multiple-axis zone is selected.
Also specify the scale of Y-axis (linear or logarithmic).
7. Click the value in the “Scale” cell and type the scale value.
The selectable range is from -10
16
to 10
16
disregarding the decimal point.
If you set the minimum value larger than the maximum value, the waveform will be
displayed flipped from top to bottom.
Note
The decimal point positions of the entered values are adjusted for each tag according to the
number of significant digits to the right of the decimal point.
Clicking the “Scale Calc” button automatically sets the minimum/maximum scale
values to the minimum/maximum values of the corresponding tag’s data.
8. Click the value in the “Zone” cell and type the value with which to display the zone.
The selectable range for minimum and maximum values are from 0 to 99% and from
1 to 100%, respectively.
Waveforms are displayed in zones where the top and bottom of the waveform
display area correspond to 100% and 0%, respectively.
9. Click the values in the “Trip 1” and “Trip 2” cells and type the display positions for trip
points 1 and 2.
Click the check boxes to specify the Use (blue) or Not Use of the trip points.
4.2 Setting the Display Conditions