Yokogawa DAQWORX - Manual (Page 14)

1-6 IM WX101-01E
• The original SET mode and SETUP mode information can be
• Loaded from the recorder via communications (receive via communications).
• Loaded from a file that is stored on a storage medium such as a floppy disk (this
is called “file importing”).
• Created from scratch.
• The settings after they are edited can be
• Written to the recorder via communications (transmit via communications).
• Stored on a storage medium and written to the recorder from the storage
medium (this is called “file exporting”).
However, the following restrictions exist depending on the recorder:
• Settings for the DX1000 and DX2000 cannot be processed by the setting
software.
• For µR recorders, the SET Mode settings can be transmitted or received via
communications.
Settings in the SETUP Mode cannot be modified. Set them directly on the µR
recorder. In addition, since no storage media drives are provided, setting using
the storage medium is not possible.
• For VR recorders, the SET Mode settings can be transmitted or received
via communications or imported or exported through files. The settings
in the SETUP Mode can be modified through file importing and exporting.
Communications cannot be used.
• For DX/CX DAQSTATION and MV MobileCorder, the setting mode and basic
setting mode settings can be transmitted or received via communications or
imported or exported through files. However, network settings (such as the IP
address) cannot be changed via communications. Set them directly on the DX
or use file exporting.
• For DARWIN, the SET Mode and SETUP Mode settings can be transmitted or
received via communications or imported or exported through files.
• If you are using a DX1000/DX1000N/DX2000 with the /AS1 option on which
users are registered, you cannot use serial communication to transmit settings.
• In addition, Hardware Configurator can be used to create settings by changing the
system configuration such as the presence or absence of options or by changing
the subunit/module configuration (for DARWIN). Use this function in situations
such as when preparing the configuration change of the connected recorder
beforehand.
• The following control commands can be transmitted to the recorders.
• Set the date and time of the recorder to the date and time of the PC (µR, VR,
DX, MV, CX, DA, DR, and DC).
• Start/Stop the recording (µR, DX, MV, CX, DR, and DC).
• Start/Stop computation (µR, VR, DX, MV, CX, DA, DR, and DC).
• Initialize the data memory (VR, DX, MV, CX, DC).
• Show the specified display (µR, VR, DX, MV, CX, DR, and DC).
• Execute reconfiguration (DA, DR200 (Expandable), and DC).
However, if you are using a DX1000/DX1000N/DX2000 with the /AS1 option on
which users are registered, you cannot use serial communication to transmit control
commands.
For the operation procedure of Hardware Configurator, see chapter 7.
• Report Generator
Determines the instantaneous value, maximum, minimum, average, sum, and total
from the data that are scanned or recorded over an hour, a day, a week, or a month
and output them to a file or print them at a specified time. Report Generator never
appears on the screen. The start and stop operation and settings of the report are
done on Software Manager.
1.1 Overview of the DAQLOGGER/DAQLOGGER Client Package