Yokogawa DAQWORX - Manual (Page 404)

7-228 IM WX101-01E
Start target setpoint
Set the start SP, a starting condition, in the range of [EU (0.0% to 100.0%)] (initial value
is 0%) of the measurement span. On Style 3 or later, the value can be set on the loop
whose Action Loop Set is ON. On Style 2 or earlier, the value can be set on loops whose
[Program Control] has been turned ON in [Internal Loop] under the [Setup] tab. During
cascade control, even-numbered loops within the same terminal block cannot be set.
Start code
Select the operation start condition from the following. However, only the possible loop
conditions are displayed.
Starting target setpoint start, PV1 to PV 6 ramp-prioritized PV start, time-prioritized ramp
start (not displayed for segment time ramp setting method)
Wait action setting
Set the wait zones for 6 (number of loops) × 5 (number of zones) (2 (number of loops)
× 5 (number of zones) for the CX1000) in the range of “EUS (0.0 to 100.0%)” of the
measurement span.
On Style 3 or later, the value can be set on the loop whose Action Loop Set is ON. On
Style 2 or earlier, the value can be set on loops whose [Program Control] has been
turned ON in [Internal Loop] under the [Setup] tab. During cascade control, even-
numbered loops within the same terminal block cannot be set.
Wait time
Set the wait time in [hh:mm:ss] format (selectable range: [00:00:00] to [99:59:59]) for all
the available zones. This item applies to all zones. You cannot set this value when the
wait zone is OFF on all loops.
Action Loop Set
Set the loops to activate.
Select from the loops whose program control is ON.
7.10 Setting CX Series