Yokogawa DAQWORX - Manual (Page 257)

7-81 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
• Batch
Batch (when the multi batch function is not installed)
Select [ON] to use the batch function.
Batch operation qty (when the /BT2 multi batch function is installed;
release number 3 or later)
Specify the number of batches to use.
Settings Description
OFF Disables the multi batch function and the batch function.
1 Enables the single batch function.
2 or higher Enables the multi batch function. The table below shows the number of
batches supported by the DX1000 and DX2000.
Model
Number of Batches Supported
DX1000 2 to 6
DX2000 (standard memory model) 2 to 6
DX2000 (large memory model) 2 to 12
• Digit of lot number
Select the number of digits of the lot number from 4, 6, or 8. Select [OFF] to disable
the lot number.
• Auto increment
ON Automatically sets the lot number of the next measurement to “the lot number of
the current measurement + 1.”
• Trend Type
Function for the DX2000 only.
Settings Description
T-Y A trend display with a linear time axis
Circular A trend display with a circular time axis
• Partial
Turn Partial [ON] (partially expand) or [OFF] (do not partially expand).
• Trend Rate Switching
ON Enables the function that switches the trend interval while the memory sampling
is in progress. The “Second interval [/div]” item is displayed in the setting mode.
• When [Trend Rate Switching] is set to [ON], you cannot set [Data Kind] under
[Environment] - [Basic Environment] in the [Basic setting] tab to [E+D].
• This setting is fixed at [OFF] if you set [Batch operation qty] to [2] or higher on models
with the multi batch function (/BT2 option; release number 3 or later).
• Write Group
Settings Description
Common Write the message to all groups.
Separate Write the message to the displayed group.
• Power-Fail Message
ON A message is written when the DX recovers from a power failure while memory
sampling is in progress.
• Change Message
ON Writes the time the interval is switched and the new trend interval as a message
when the trend interval is switched. On DXs with the /AS1 advanced security
option, a message is written even when the setting mode setup items are
changed during memory sampling.
7.7 Setting DX1000/DX2000