Yokogawa DAQWORX - Manual (Page 199)

7-23 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
Alarm value
Alarm is generated using the specified value as the boundary. The selectable range of
alarm values vary depending on the input mode and range.
Alarm delay
Alarm is generated when the measured value stays above or below the specified alarm
value for the specified time (delay period).
Relay
To output relays, select the output relay number. Otherwise, select [NONE].
Input Filter and Moving Average
Moving average can be specified on models DX106, DX112, DX210, DX220, DX230,
MV106, MV112, MV210, MV220, and MV230.
Input filter can be specified on models DX102, DX104, DX204, DX208, DX204C,
DX208C, MV102, MV104, MV204, and MV208.
Input filter
To use the input filter, select the time constant (2 s, 5 s, or 10 s).
Moving average
To use the moving average, select the sampling count (2 to 16).
Tag
Up to 16 characters can be entered for the tag.
You can use the tag instead of the channel number to be displayed on the screen.
The [Setup] screen is used to select whether to display the channel number or the tag on
the screen.
Display Zone
You can select the range of the screen in which the waveform of each channel is to be
displayed.
Specify positions (%) on the display scale for the upper and lower limits.
The conditions for setting the zones are as follows:
• Range: 0% to 100%
The lower limit must be less than the upper limit
• The difference between the lower and upper limits is at least 5%.
Graph
Divisions
Select the number of bar graph divisions.
Bar graph
Select the reference position of the bar graph. Selecting [Center] when the bar graph is
vertical produces no effect.
It is set back to [Normal] when the data are checked.
Scale
When using scale display on the trend screen, select the position to display the scale.
For details related to divisions, bar graph, and scale, see section 7.10 in the DX100/
DX200/DX200C/MV100/MV200 User’s Manual.
7.6 Setting DX100, DX200, MV100, MV200