Yokogawa DAQWORX - Manual (Page 475)

9-5 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Error Messages and Their Corrective
Actions
DAQLOGGER Manager
Error
Code Error message What to do
E3503 Password was confirmed incorrectly. Enter the password correctly in the “Password” and
“Confirm” boxes.
E3504 Invalid password. Enter the correct password.
E3505 Cannot exit DAQLOGGER Manager while Stop the scanning operation before quitting the
scanning/recording is in progress. DAQLOGGER Manager.
E3506 Cannot contain any of the following characters: \ / : , ; * ? “
< > | Use characters other than \ / : , ; * ? “ < > |.
E3507 File name is too long. Use a shorter file name.
E3508 Cannot exit DAQLOGGER Manager while Desktop
protection is active. Cancel desktop protection before quitting the
DAQLOGGER Manager.
E3509 Cannot exit DAQLOGGER Manager while Password
protection is active. Cancel password protection before quitting the
DAQLOGGER Manager.
E3510 Cannot shut down Windows while DAQLOGGER is being
used. Quit the DAQLOGGER Manager before shutting
down Windows.
E3511 Cannot delete project. At least one supervisor project
must remain. — — — — (You cannot delete the only Supervisor
project.)
E3512 Cannot delete project. At least one project without
password must remain.
— — — — (You cannot delete the only project that
uses no password function.)
E3513 In the same level a project with the same name already
exists.
— — — — (You cannot create a project of the same
name and level.)
E3514 Cannot be terminated while the Event Processor is in
operation.
Wait for the Event Processor operation to complete
and
then terminate the Manager.
E3515 Cannot be executed while the Event Processor is in
operation. Wait for the Event Processor operation to complete
and then execute.
Message
Code Message What to do
M3561 Stop Recording? — — — —
M3562 Save all data before exiting DAQLOGGER software? — — — —
M3564 Delete project? — — — —
M3565 Disconnect the recorder? — — — —
Report Generator
Error
Code Error message What to do
E3601 Please complete report configurations before starting to
report. If no output destination has been specified in the
report configuration setting, specify the output
destination. If no computation type has been
specified, specify the computation type(s) of the data
to be reported.
Message
Code Error message What to do
E4000 Cannot send command while computations are in
process. Check the connected recorder.
E4001 Failed to send command. Settings don't fit currently
connected model or memory sampling may be in process. Check the connected recorder.
E4002 Cannot send command while reporting are in process. Check the connected recorder.
9.1 Error Messages and Their Corrective Actions