Yokogawa DAQWORX - Manual (Page 33)

2-13 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Configuring the DAQLOGGER
2.6 Setting Communications and the Connected
Recorder
To communicate directly with the recorder and acquire the measured/computed data,
you must correctly configure the communication system with the connected recorder
and correctly set the recorder (type, the number of inputs, etc.). In addition, if you
are acquiring the measured/computed data via the Ethernet network with a PC that
has DAQEXPLORER, DAQ32Plus, DAQLOGGER, MXLOGGER, and Gate software
applications installed, you must set parameters such as the IP address of the target PC
and the port number of the monitor server.
Setting the Environment When Communicating Directly with the Recorder
Setting serial communications (only for serial communications)
Set the serial interface port. The data length is fixed to 8 bits.
Procedure
1. In the “DAQLOGGER Manager” window, press the “ENVI” button. Software
Configurator starts and its window opens.
The address is reassigned, starting from the smallest
address number available, to the recorders in the
selected range that are connected via RS-422 in the
order of the record numbers.
Switches the “Expandable/Standalone” setting of the
DARWIN recorders in the selected range at once.
Switching the “Expandable/Standalone” setting
initializes the settings (see page 2-20).
Copies the settings of the first recorder
number in the selected range to the
settings of all the recorder numbers in
the selected range.
Initializes the settings of the recorder
numbers in the selected range. Initialization
refers to the act of removing recorder
assignments from recorder numbers and
clearing all other settings as well.