Yokogawa DAQWORX - Manual (Page 180)

7-4 IM WX101-01E
7.2 Loading the Setting Parameters
Load the setting parameters from the connected recorder.
Procedure
1. In the menu bar, select “Communication” then “Receive.”
The “Select Recorders” dialog box opens.
2. Select the recorders from which to receive data, then click the “Receive” button.
• To select all the recorders Click “Select All.”
• To select individual recorders In the list, currently connected recorders are
shown in blue. Click the recorder from which you wish to receive data and it turns
red. You can select more than one recorder.
3. When the setting parameters from the recorder have been received, a
“Communication Message” dialog box appears. Read the message and click “OK.”
Note
• You cannot load the setting parameters by the “Receive” command operation while the
scanning or recording is in progress.
• In some cases, the system configuration may not be properly loaded from VR and µR
recorders. Please check that the system configuration that was loaded matches that of the
recorder. If is does not, refer to sections 7.4 and 7.5 and correct the system configuration
so that they do match.
• As for VR series recorders, you cannot load the setting parameters by the “Receive”
command operation described in the previous pages. Use the “File Import” function instead
(See section 7.12 “Handling Settings Data Using a Floppy Disk”).
• Data cannot be received when the Logger Monitor or Record function is active.
• When using Ethernet, error detection may take a few minutes.
• When data were acquired with the DC100, a message may appear warning you that some
changes have taken place. In that case, please check if all data have been acquired.
• In the “DAQLOGGER Hardware Configurator” window, possible menu bar operation varies
depending on the project’s operation level.
• For more information about this limitation on operation, see section 2.5, “Setting the
Security.”