Yokogawa DAQWORX - Manual (Page 346)

7-170 IM WX101-01E
Selecting the Alarm Printout (DR only)
This setting can be selected from the following. The default setting is ON2.
OFF: Alarm printout will not be carried out;
ON1: Alarms will only be printed out on occurrence.
The alarm occurrence mark, channel No. or tag, type of alarm, alarm heading or time of
occurrence will be printed with trend recordings.
ON2: Alarms will both be printed out on occurrence and release.
The alarm occurrence/release mark, channel No. or tag, type of alarm, alarm heading or
time of occurrence/release will be printed with trend recordings.
Alarm print ON/OFF
Message setting
Selecting a Message Printout (DC100, DR only)
This setting specifies whether to print a message on alarm occurrence, and if so, which
message will be printed. The default setting is OFF.
OFF: No message will be printed.
See also “Setting Messages (DC100, DR Only).”
Setting Moving Average and Filter
Moving Average (MOVE AVE)
Moving average can be set for each channel individually. The number of samples used
for the moving average can be set from 2 to 64.
Filter Settings
Setting the Filter ON can eliminate pulse chattering of up to 5 ms.
Recording-related Settings (DR Only)
In this Section the following recording-related setting for DR:
• Recording zones
• Partially expanded recording
• Interpolation
• Trend recording
• Digital printout ON/OFF
• Manual printout ON/OFF
• Scale printout ON/OFF
• List printout ON/OFF
7.9 Setting DARWIN