Yokogawa DAQWORX - Manual (Page 354)

7-178 IM WX101-01E
RECORD (DR only)
• ON: Starts recording. The recording format is set individually. For details, see “Setting
the Recording Format,” on page 7-163.
• OFF: Stops recording. The level action does not include record ON/OFF functions.
• When the level action is set, the ON/OFF functions using the RECORD key are
disabled.
• The edge and level actions cannot be set simultaneously.
• For the level action, only one action is available.
MANUAL PR (DR only)
Enables manual printing.
DIGITAL PR (DR only)
• Digital printing starts in the analog trend mode. The recording intervals depend on
the timer setting (see page 7-152). When the event/action functions are set, normal
digital print functions are disabled.
• Only one setting can be made in the event/action function.
MSG PR (DC100, and DR only)
• Prints messages.
• Select any message from the corresponding codes 01 to 20.
MSG DISP (DC100, and DR only)
• Displays messages.
• Select any message from the corresponding codes 01 to 20.
• To cancel the message display, press any key.
SPEED CHG (DR only)
• Changes chart speed 1 to chart speed 2. When the recording interval is set to
automatic, the recording interval is also changed. When the event is released, the
chart speed and recording interval return to their original positions.
• Only one setting can be made in the event/action function.
GR TREND (DR only)
• This executes the recording in a channel in which the group setting has already
been made. For this, set the dot-recording to “GROUP” and start recording by key
operations following the “RECORD” given above.
• Select any group from G01 to G07.
• Only one identical group can be set in the event/action functions.
Note
• If Chart End appears, counter-actions such as RECORD ON are not executed.
• Actions such as RECORD or SPEED CHG may operate later than an event occurrence.
For example, with RECORD set in the action setting, if an alarm occurs, the measured
values in that condition are not recorded. This is because recording operations are delayed
due to an action operation.
MATH (for instruments with /M1 option or FDD option only)
• START : Starts computation.
• STOP : Stops computation.
• RESET : Resets computation channel data at the end of completion of the first
computation in case an event takes place.
• CLEAR : Resets computation channel data immediately in case an event takes place.
• If MATH is selected as a level action, computation will be carried out while an event is
present. Computation will stop when the event is cleared.
MEMORY (for DC100, and DR with FDD option only)
DR with FDD option
• DATA_WR : Saves a data item each time an event occurs, until the specified data
length is reached.
7.9 Setting DARWIN