Yokogawa DAQWORX User Manual

Page 412

Advertising
background image

7-236

IM WX101-01E

AUX (Automatic Message, Display Position)

Turn message display ON/OFF, and set the loop display position on the CX.

Message displays on the CX trend display screen

Display position when loop display on the CX is partitioned

Tag display (settings cannot be entered here)

Tag comment display (settings cannot be entered here)

Auto change to program run display ON/OFF (style number S3 or later)

On/Off

If you select [On] (initial setting), a message is automatically written on the trend display

when program control is started and when program control is stopped as shown in the

figure below. If you do not wish to write messages, select [Off]. The message when

starting program operation is “PROGRAM RUN”; the message when stopping the

program operation is “PROGRAM RESET.”

Position

On the program selection display and program control display, the specified patterns and

PV waveforms can be displayed in the same display frame (full display) as well as display

data by dividing the display position per loop (split display). When using split display,

select the display position number from [1] to [6] for each loop. On Style 3 or later, the

value can be set on the loop whose Action Loop Set is ON. On Style 2 or earlier, the

value can be set on loops whose [Control Mode] has been set to a mode other than [Off]

and [Program Control] to [On] in [Internal Loop] under the [Setup] tab. During cascade

control, even-numbered loops within the same terminal block cannot be set.

Auto change to program run display (style number S3 or later)

You can set the screen to switch to the Program Control Display when a program

execution command is received using the communication function.

ON:

When a program execution command is sent, the screen switches to the Program

Control Display.

OFF: The screen does not switch to the Program Control Display even when a program

execution command is sent (default).

7.10 Setting CX Series

Advertising
This manual is related to the following products: