Yokogawa DAQWORX - Manual (Page 347)

7-171 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
Left recording zone
Right recording zone
List print ON/OFF
Scale value print ON/OFF
Manual print ON/OFF
Digital print ON/OFF
Trend recording ON/OFF
Boundary value
Interpolation ON/OFF
Partially expanded
recording settings
Setting Recording Zones (ZONE)
The set left and right position of the zone correspond to the left and right span set at the
SPAN menu (recording span). The minimum width of a zone is 5mm. No decimal points.
This setting can also be made for computation channels A01 to A60.
Partially Expanded Recording (PARTIAL)
This setting specifies whether to carry out partially expanded recording, and if so, which
percentage of the recording span will be compressed and the corresponding boundary
value.
This setting can also be made for computation channels A01 to A60.
• Notes on Partially Expanded Recording
• Partial recording cannot be carried out if the input type of the computation channels
is SKIP or DI or if the computation channels are OFF.
• Partially expanded settings will be automatically canceled when either of the
following changes occur.
• the input type has been changed;
• the measurement range has been changed;
• the recording span has been changed;
• linear scaling settings have been changed;
• the reference channel for difference between channels has been changed.
Interpolation (INTERPOL)
This setting can also be made for computation channels A01 to A60. The default setting
is OFF.
Trend Recording
Recording can be set ON/OFF per channel. The default setting is ON.
Digital Printout Setting (DIGITAL PR)
This setting applies to the digital print of the analog mode and logging mode.
Manual Printout Setting (MANUAL PR)
OFF: Manual printout will not be carried out for this channel;
ON: Manual printout will be carried out for this channel.
This setting can also be made for computation channels A01 to A60.
Scale Printout (SCALE PR)
The scaled values will be printed out with trend recordings. This setting can also be
made for computation channels A01 to A60.
List Printout (LIST PR)
Setting information per channel will be printed. Starting a list printout can be done at the
PRINT menu. This setting can also be made for computation channels A01 to A60.
7.9 Setting DARWIN