Yokogawa DAQWORX - Manual (Page 415)

7-239 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
Memory Sample (save method of measured/computed data)
• Save
Select the save method of internal memory data to an external storage media from
[Auto] or [Manual].
Manual: Inserting the external storage media into the drive and closing the cover
displays the “Save confirmation” message, allowing data to be saved.
When the operation is complete, remove the external storage media from
the drive, so that the next set of data save operation can be performed. You
can select whether to save all of the data from internal memory or only to
update the data still not saved to an external storage media.
Auto: If an external storage media is always in the drive, data is saved
automatically at a preset interval.
• Data
Select the data to be written to internal memory from the following: [DISPLAY]
(displayed data only), [EVENT & DISP] (event data and displayed data), or [EVENT]
(event data only).
• Event Data Sampling Rate
Select the interval at which event data is saved from the following: [1s], [2s], [5s], [10s],
[30s], [60s], [120s], [300s], or [600s].
• Event Data Sampling Mode
Select [Free], [Trigger] or [Rotate].
• Block
When the data type is [EVENT], select 1, 2, 4, 8, or 16.
When the data type is [EVENT & DISP], select 1, 2, or 4.
• Data Length
Set the interval corresponding to the amount of data (data length) that can be written
as a block of the event data storage region. The data length that can be set depends
on the event data sampling rate. It also depends on the block setting and number of
Meas and Math channels.
• Pre-Trigger Length
If 0 is selected, the event file entirely consists of data after the trigger. If 100 is
selected, the event file entirely consists of data before the trigger.
• Manual Trigger
When applying triggers with keys, select [ON].
• External Trigger
When applying trigger signals by remote input, select [ON].
• Alarm Trigger
When applying alarms as triggers, select [ON].
• Sampling
Select the channels to be saved to the memory.
7.10 Setting CX Series