Yokogawa DAQWORX - Manual (Page 273)

7-97 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
When obtaining the IP address from DHCP
• DHCP
Set [DHCP] to [ON].
• DNS accession
To automatically obtain the DNS server address, select [ON]. Otherwise, select [OFF].
If you select [OFF], you must set the IP address of the DNS server.
• Host-Name Register
To automatically register the host name, select [ON].
• Host Name
Set the DX1000/DX2000’s host name using up to 64 alphanumeric characters.
• Domain Name
Set the network domain name that the DX belongs to using up to 64 characters.
• Server Primary, Server Secondary (not necessary when DNS accession
is enabled)
Register up to two IP addresses for the primary and secondary DNS servers.
• Domain Primary, Domain Secondary
Set up to two domain suffixes: primary and secondary.
Keep Alive
To disconnect when there is no response to the test packets that are periodically sent,
select [ON]. Otherwise, select [OFF].
Time out
To use the application timeout function, select [ON]. Otherwise, select [OFF]. If you
select [ON], a [Timeout time] is displayed.
• Timeout time (min.)
Set the timeout value between 1 and 120 (minutes).
Checking the communication status
The Ethernet communication status can be confirmed with the LED lamp that is provided
on the Ethernet connector on the DX1000/DX2000 rear panel or the [Ethernet link] that is
shown at the upper right of the basic setting screen.
7.7 Setting DX1000/DX2000