Yokogawa DAQWORX - Manual (Page 70)

2-50 IM WX101-01E
6. Specify the base time and date.
This is the date and time the reports are created.
Specify the time for hourly reports, date and time for monthly reports, and day and
time for weekly reports. The time is common to all reports (hourly, daily, weekly, and
monthly reports).
Note
If you specify 29th, 30th, or 31st for the “Base Date” for monthly reports, the date of the report
generation on months that do not have these dates are set to the equivalent dates of 29th,
30th, and 31st as shown in the following example.
Example: If the “Base Date” is set to “31st,” the report for June is created on the following day
of June 30th, which is July 1st (at the base time). The report for July is created on the data
between July 2nd and July 31st.
7. Specify the time unit of integration (“Sum Unit”)
Click the sum or accumulating total cell and select the unit of integration from the list
box. The list box shows “None,” “Second,” “Minute,” “Hour,” and “Day.”
If you select the “by calculate” check box in the “Sum Unit” column, the unit of
integration applies to both sum and accumulating total (Changing one unit changes
the other).
If you select the “by Report” check box in the “Sum Unit” column, the selected unit of
integration is set to the unit of integration for the same computation of the same tag
for all types of reports.
Setting the Printer
Set the printer used to print the reports.
Printer setting operation is the same as that of the print command of Windows.
Procedure
1. In the “DAQLOGGER Report” dialog box, click “Print Setup” at the bottom of the
window.
The “Print Setup” dialog box appears.
2. Set the items in the dialog box, and then click “OK.”
Saving the Report Configuration
Save the current settings and terminate configuration.
Procedure
1. In the “DAQLOGGER Report” dialog box, click “OK” at the bottom of the window.
The setting data are saved, and the dialog box closes.
Redisplaying the Current Settings
To cancel the current setting operation and redisplay the setting data before the
operation, do the following.
Procedure
1. In the “DAQLOGGER Report” dialog box, click “Revert” at the bottom of the dialog
box.
The current data settings are discarded and the data before the setting operation are
displayed.
2.10 Configuring the Report Function