Baud rate selection – Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual User Manual
Page 100
Publication 1760-UM002B-EN-P - March 2005
3-22 Commissioning
The menu BAUDRATE: 9600B will appear. The two baud rates are for 9600
or 19200 baud. Select the baud rate that your connection will support.
Baud Rate Selection
:
1.
Press the OK button.
2.
Select 19200 baud as the baud rate.
3.
Press the up/down arrow button.
4.
Confirm with the OK button.
5.
Switch on the COM connection.
6.
Press the press the down arrow button.
7.
Press the OK button.
The tick on the Serial Interface menu item indicates that Serial Interface
has been selected.
No tick means that Serial Interface has not been selected.
BAUDRATE: 9600B
Serial Interface
REMOTE MARKER...
IMPORTANT
Select 19200 baud as the baud rate. Badly laid cables may
give rise to electromagnetic interference. Select 9600 baud
as the baud rate. If this is not satisfactory, the connection
cable must be laid in a different location.
BAUDRATE:
192
00B
Serial Interface
REMOTE MARKER...
IMPORTANT
The Serial Interface must only be switched at the
active station. Two devices with Serial Interface
✓
switched on cannot communicate with each other.
BAUDRATE:19200B
Serial Interface
✓
REMOTE MARKER...
IMPORTANT
The following applies to the active station:
If you wish to run data transfers between the two
devices in both directions, you must select the
marker range on the active station.