Mounting the display/keypad, “front mounting – Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual User Manual
Page 40
![background image](/manuals/579694/40/background.png)
Publication 1760-UM002B-EN-P - March 2005
2-6 Installation
Mounting the Display/Keypad, “Front Mounting”
Figure 2.8 Drill holes for the GFX
Drill and punch out two 22.5 mm diameter holes. The diameter is the same as
is normally required for control circuit devices.
IMPORTANT
Observe the following technical requirements:
• The hole spacing is 30 mm.
• The maximum thickness of the front plate for
mounting the processor unit must not be more than
6 mm.
• The maximum thickness of the front plate for
mounting an expansion unit with a DIN rail in addition
to the processor unit must not be more than 4 mm.
• Leave enough space at the side for the processor unit,
and if necessary, the expansion unit.
• In order to ensure protection to IP65, the surface of the
mounting front must be even and smooth.
30
22.5
MFD-CP...