Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 109)

Publication 1760-UM002B-EN-P - March 2005
Commissioning 3-31
The following applies if the device to be operated is in RUN mode and is
displaying a screen:
This screen is not displayed in Terminal mode.
GFX message: “The remote device is in Graphic mode.”
1. Press the ALT and ESC button simultaneously.
This will call up the Status display.
Pico-Link station 2 controls the display of the GFX device.
IMPORTANT
If the text “Connection establishment in progress...” is
displayed for longer than 10 s, the connection to the
selected device is faulty. Press ESC to cancel the
selection. Rectify the fault. Try to re-establish the
connection.
I 1..4..789... *
I NT2 P-
TU 06.05.2003
Q 1..45678 RUN
TIP
The activation of Terminal mode is indicated by the
flashing star at the top right of the Status display.
ATTENTION
In Terminal mode, you can operate a device that
may be positioned far from your actual location. All
access rights that you would also require "locally" are
granted to you. It is not always possible to obtain a
view of the situation “locally”. Use of this operating
mode and the execution of any changes to device
settings should only be carried out with the utmost
caution.
A device with a display and keypad can also be
operated locally. In this case, operation at the device
concerned is always faster than operation via
Terminal mode. Bear in mind that this may lead to
conflicts that may trigger faults or unforeseen events.