Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 48)

Publication 1760-UM002B-EN-P - March 2005
2-14 Installation
3. Hook the Pico GFX-70 to the top edge of the DIN rail and hinge into
place while pressing down slightly.
4. Press down lightly on both the device and the DIN rail until the unit
snaps over the lower edge of the DIN rail. The Pico GFX-70 will clip
into place automatically.
5. Check that the device is seated firmly.
The device is mounted vertically on a DIN rail in the same way.
Screw Mounting
The processor unit can be screwed onto a mounting plate without the
display/keypad.
For screw mounting on a mounting plate, mounting feet must be used that can
be fixed to the back of the Pico GFX-70. The mounting feet are available as an
accessory.