Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 35)

1 Publication 1760-UM002B-EN-P - March 2005
Chapter
2
Installation
The Pico GFX-70 must only be installed and wired by qualified electricians or
other persons familiar with the installation of electrical equipment.
The Pico GFX-70 is installed in the following order:
• Mounting
• Wiring the inputs
• Wiring the outputs
• Wiring the Pico-Link (if required)
• Setting up the serial interface (if required)
• Connecting the power supply
Mounting Install the display/keypad of the GFX in the front of a control cabinet, a
service distribution board, operator panel or in an enclosure. Install the
processor unit and the input/output module so that all the terminals are
protected against direct contact, liquids and dust during operation.
When using the GFX without a display/keypad, snap it onto a DIN EN50022
DIN rail or fix it in place using mounting feet. The GFX can be mounted
either vertically or horizontally.
WARNING
Danger of electric shock!
Never carry out electrical work on the device while the
power supply is switched on.
Always follow the safety rules:
• Switch off and isolate.
• Ensure that the device is no longer live.
• Secure against reclosing.
• Short-circuit and ground.
• Cover adjacent live parts.
TIP
When using the Pico GFX-70 with expansion units,
connect the expansion unit before mounting. (See Connecting
the Expansion Unit on page 2-16).