Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 330)

Publication 1760-UM002B-EN-P - March 2005
7-2 Pico GFX-70 Settings
Password Setup
A password can be set via the System menu regardless of the RUN or STOP
modes. You cannot change to the System menu if a password is already
activated.
1. Press DEL and ALT to call up the System menu.
2. Select the menu option SECURITY… to enter the password.
3. Press the OK button and change over to the PASSWORD… menu.
4. If you press the OK button again, you will access the password input.
If no password has been entered, Pico GFX-70 changes directly to the
password display and displays six dashes: No password available.
5. Press OK, six zeros will appear
6. Set the password using the cursor buttons:
– left and right arrow key to select position in password,
– up and down arrow key to set a value between 0 to 9.
IMPORTANT
A password that has been entered in Pico GFX-70 is
transferred to the memory module together with the circuit
diagram, irrespective of whether it was activated or not.
If this Pico GFX-70 circuit diagram is loaded back from the
memory module, the password will also be transferred to
Pico GFX-70 and is activated immediately.
ENTER PASSWORD
❚-----