Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 43)

Publication 1760-UM002B-EN-P - March 2005
Installation 2-9
Attach the expansion unit before fitting the DIN rail.
Figure 2.12 Fitting the DIN rail
1. Fit the DIN rail in the groove using the slide catch of the processor unit
and the expansion unit.
2. Turn the DIN rail towards the housing.
3. Let the DIN rail snap into position.
4. Press the processor unit onto the fixing shaft.
IMPORTANT
The two fixing shafts of the display/keypad are designed
for a 2 space unit expansion device.
If you wish to fit wider expansion units, the DIN rail must
be supported at a third support point.
This third support point should be located in the area
216 mm from the end of the device. It should not be
possible to twist the DIN rail.
ATTENTION
The fixing shafts of the display/keypad are designed for
mounting the expansion units. Other devices such as
contactors must not be mounted on this DIN rail.