Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 367)

Publication 1760-UM002B-EN-P - March 2005
Inside Pico GFX-70 8-13
Loading or Saving Circuit Diagrams
You can only transfer circuit diagrams in STOP mode.
The Pico GFX-70 versions without a keypad and display automatically transfer
the circuit diagram from the inserted memory module to the GFX processor
when the power supply is switched on. If the memory module contains an
invalid circuit diagram, Pico GFX-70 will keep the circuit diagram still present
on the device.
1. Switch to STOP mode.
2. Select PROGRAM… from the main menu.
3. Select the CARD… menu option.
The CARD… menu option will only appear if you have inserted a
functional memory module.
You can transfer a circuit diagram from Pico GFX-70 to the memory
module and from the memory module to the Pico GFX-70 memory or
delete the content of the memory module.
4. After transmission, remove the memory module and close the cover.
Saving a Circuit Diagram on the Memory Module
1. Select DEVICE-CARD.
2. Confirm the prompt with OK to delete the contents of the memory
module and replace it with the Pico GFX-70 circuit diagram.
3. Press ESC to cancel.
IMPORTANT
If you are using a display without a keypad, load the
programs with the PicoSoft Pro software. The function for
automatically loading from the memory module on power
up is only supported on GFX processor without display
and keypad.
PROGRAM
DELETE PROG
CARD…
DEVICE-CARD
CARD-DEVICE
DELETE CARD
IMPORTANT
If the operating voltage fails during communication
with the memory module, repeat the last procedure
since Pico GFX-70 may not have transferred or
deleted all the data.
REPLACE ?