Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 338)

Publication 1760-UM002B-EN-P - March 2005
7-10 Pico GFX-70 Settings
3. Select the required function block using the up/down arrow keys.
4. Press the OK button.
5. Scroll through the constants of the function block inputs.
6. Change the values for a parameter set:
– With OK in the Entry mode.
– Left/right arrows to change decimal place
– Up/down arrows to change the value of a decimal place
– OK save constants or
– ESC retain previous setting.
7. Press ESC to leave the parameter display.
Adjustable Parameters for Function Blocks
You can modify the function blocks used in the circuit diagram in three
different ways:
• All circuit diagram parameters can be adjusted in STOP mode via the
function block editor.
• Set point (constants) can be modified in RUN mode via the function
block editor.
• Set points (constants) can be modified via the PARAMETERS menu.
Adjustable set point values are:
• The inputs with all function blocks if constants have been used.
• Switch on and off times with time switches.
In RUN mode Pico GFX-70 operates with a new set point as soon as it has
been modified in the parameter display and saved with OK.
T 03 S +
>I1 020.030
>I3 005.000
QV> 012.050
IMPORTANT
Only constants on the function block inputs can be
changed.