Setting up the serial interface -21, Setting up the serial interface – Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual User Manual
Page 99
Publication 1760-UM002B-EN-P - March 2005
Commissioning 3-21
4.
Ensure that the power supply for both stations is switched on. The
POW LED must light up or flash. It is only possible to configure the
stations which have an active power supply.
5.
Go to the GFX device that is the active station running the serial
interface.
Setting up the Serial Interface
1.
Simultaneously press the DEL and ALT buttons with the Status display
active.
The System menu appears
2.
Select the CONFIGURATOR menu option.
3.
Press the OK button.
4.
Select the COM... menu option.
5.
Press the down arrow button.
6.
Press the OK button.
IMPORTANT
The following tasks are only possible in STOP mode.
ATTENTION
The GFX device can either run as a Pico-Link station
or as a station in a Serial Interface connection. Do
not switch a GFX device running as a Pico-Link
station to Serial Interface. If this is done with the
Pico-Link in the RUN mode, the entire Pico-Link
network will be deactivated. There will be no further
data transfer.
Solution:
1.
Deactivate the Serial Interface.
2.
Re-enter the Pico-Link address.
3.
Switch the power supply off and then on again.
4.
Reconfigure the Pico-Link on station 1.
SECURITY...
SYSTEM...
MENU LANGUAGE
CONFIGURATOR...
NET..
COM...
LINK....