Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 138)

Publication 1760-UM002B-EN-P - March 2005
4-28 Wiring with Pico GFX-70
• STOP: Creation of the circuit diagram
• RUN: Power flow display
4. Switch on I3.
Figure 4.14 Power flow display
In the power flow display, energized connections are thicker than
non-energized connections.
You can follow a current-carrying connection across all circuit connections by
scrolling the display up and down.
The bottom right of the power flow display indicates that the controller is in
RUN mode. See Power Flow Display with Zoom Function on page 3-11.
.
Function Block Editor
The Pico GFX-70 has the FUNCTION RELAYS menu for editing the
function blocks without circuit diagrams. The function blocks are an inherent
component of the program.
IMPORTANT
The power flow display will not show signal fluctuations in
the millisecond range. This is due to the inherent delay
factor of LCD displays.
I 02-- | ------------------------S Q 04
I 03-- |
L:001 C:1 RUN