Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 304)

Publication 1760-UM002B-EN-P - March 2005
5-36 Visualization with Pico GFX-70
Figure 5.40 Message text with default text
Message Text Example Program 5 – Several Message Texts in One Text Element
The program consists of three screens that you can select via the up and down cursor
buttons. The screen change was defined in the Button editor (see Button Editor on page
5-37). The purpose of this program is to display several messages in one message text
element. The Visibility and Display change tabs are also covered. The clock pulse T01
activates counter C01. This counts up to 7 and then resets itself automatically. This
therefore produces a continuous loop that activates the individual messages.
Standard path: C:\Program Files\PicoSoft 6 Pro\samples\
Program: Six messages in one Message text module_manual screen
change.e60
Screen 1 - The first screen contains a message text element with six message
texts.
• Status value 1: Message text “These”
• Status value 2: Message text “are six”
• Status value 3: Message text “message texts”
• Status value 4: Message text “in one”
• Status value 5: Message text “message text”
• Status value 6: Message text “element!!!”.
It can be seen that the messages can be moved within the entry field.
Screen 2 - Screen 2 is almost the same as screen 1 apart from one addition
which enables the message text element to be made invisible via I1 (make
contact bit logic). The use of the break contact bit logic would make the
element visible.
Figure 5.41 Make message text invisible
I1 not actuated I1 actuated
Error default:
RESTART
Invisible via
I1!
Message texts
Invisible via
I1!