Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual User Manual
Page 46
Advertising
Publication 1760-UM002B-EN-P - March 2005
2-12 Installation
Remove the I/O module.
Removing the Processor Unit
The processor unit can be removed with or without the I/O module.
Use a screwdriver with a 100 x 3.5 mm slot width.
1.
Insert the screwdriver into the lug of the fixing shaft catch.
2.
Lever out the slide catch.
3.
Pull out the processor unit from the fixing shafts.
IMPORTANT
If there is another fixing point for the DIN rail, apart from
the one for the display/keypad, undo it.
Advertising