Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 62)

Publication 1760-UM002B-EN-P - March 2005
2-28 Installation
Connecting the Outputs The Q... outputs function inside the Pico GFX-70 as isolated contacts.
Figure 2.31 Output “Q”
The respective relay coils are actuated in the Pico GFX-70 circuit diagram via
the output relays Q 01 to Q 04 or S 01 to S 06 (S 08). You can use the signal
states of the output relays as make or break contacts in the Pico GFX-70
circuit diagram for additional switching conditions.
The relay or transistor outputs are used to switch loads such as fluorescent
tubes, filament bulbs, contactors, relays or motors. Check the technical
thresholds and output data before installing such devices. (See page A-1.)
Connecting Relay Outputs 1760-IB12XOW4IF, 1760-IB12XOW4IOF
Figure 2.32 1760-IB12XOW4IF, 1760-IB12XOW4IOF relay outputs
Q1
1 2
0 V H, N
L1, L2, L3 (115/250 V h)
+24 V H
Q1
1 2
f 8 A/B 16
f 10 000 000
Q2
1 2
... ... ...
Q3
1 2
M
Q4
1 2
25 000
R
24 V H 8 A
115 V h 8 A
230 V h 8 A 2 A
2 A
2 A
1000 W
10 x 58 W