Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 390)

Publication 1760-UM002B-EN-P - March 2005
A-18 Specifications
Table A.19 Function Block Coils
Coil Meaning of abbreviation Description
C_ count input Counter input
D_ direction input Count up/down indicator
ED enable Differential component Activate differential component
EI enable integral component Activate integral component
EN enable Enable module
EP enable proportional component Activate proportional component
RE reset Reset actual value to zero
SE set enable Set to a predefined value
ST stop STOP block processing
T_ trigger Trigger coil
Table A.20 Function Block Contacts
Contact Meaning of abbreviation Description
CY carry Status “1”, if the value range is
exceeded; (carry)
E1 error 1 Error 1, dependent on function block
E2 error 2 Error 2, dependent on function block
E3 error 3 Error 3, dependent on function block
EQ equal Comparison result, status 1 if values
equal.
FB fall below Status “1”, if the actual value is less
than or equal to the lower set point
value;
GT greater than Status 1 if the value at I1 > I2;
LI limit indicator Value range manipulated variable
exceeded
LT less than Status 1 if the value at I1 < I2;
OF overflow Status “1”, if the actual value is
greater than or equal to the upper set
point value;
Q1 output (Q1) Switch output
QV output value Current actual value of the function
block (e.g. counter value)
ZE zero Status “1”, if the value of the element
input QV is equal to zero;