Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 107)

Publication 1760-UM002B-EN-P - March 2005
Commissioning 3-29
Proceed as follows:
Your Pico-Link or point-to-point serial interface must be running correctly.
1. Press the OK button from the Status Display.
The first menu will appear.
2. Press the Up Arrow button.
This will display the TERMINAL MODE menu item.
3. Press the OK button.
The START MODE menu item will flash.
4. Press the Up Arrow button.
ATTENTION
Data collision!
To ensure proper operation, the following conditions must
be observed.
The following applies:
If there is more than one GFX device in Terminal
mode, each GFX device must access a different
Pico-Link station.
A device running in Terminal mode must not access
any two devices communicating with each other in
Terminal mode.
If a PC with PicoSoft Pro or a GFX device with a
serial interface is in active communication with a
Pico-Link station, this station must not be accessed at
the same time in Terminal mode via the Pico-Link.
PROGRAM...
STOP
✓
RUN
PARAMETERS
SET CLOCK...
STOP
✓
RUN
PARAMETERS
SET CLOCK...
TERMINAL MODE...
STATION ID: 0
START MODE