Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 86)

Publication 1760-UM002B-EN-P - March 2005
3-8 Commissioning
Wiring
Pico GFX-70 displays a small arrow
l
in the circuit diagram when creating the
wiring.
1. Press ALT to activate the wiring arrow cursor and use the arrow buttons
to move it.
The wiring arrow works between contacts and relays. When you move
the arrow onto a contact or relay coil, it changes back to the cursor and
can be reactivated with ALT if required.
2. Press ALT to wire the cursor from
I 02
through to the coil field.
The cursor changes into a flashing wiring arrow and automatically
jumps to the next possible wiring position.
3. Press the left arrow button. Contact
I 02
will be connected up to the coil
field.
4. Press the left arrow button again.
The cursor will move to the coil field.
5. Press OK.
Pico GFX-70 inserts the relay coil
Q 01
. The specified coil function
[
and the output relay
Q 01
are correct and do not have to be changed.
Your first working Pico GFX-70 circuit diagram now looks like this:
TIP
ALT also has two other functions depending
on the cursor position:
• In the left contact field, you can press ALT
to insert a new empty circuit connection.
• The contact under the cursor can be
changed between a make and break contact
by pressing the ALT button.
❚❚❚❚❚❚❚
-
❚❚❚❚❚❚❚
-
❚❚❚❚
l
❚❚
-
❚❚❚❚❚❚❚
-
❚❚❚❚❚❚❚
-
❚❚❚❚❚❚❚
-
L: 1 C:1 B:7944
M
l
L
m
TIP
Pico GFX-70 automatically wires adjacent contacts
in a circuit connection up to the coil.
-I 02 l
TIP
You can use DEL to erase a connection at the
cursor or arrow position. Where connections
intersect, the vertical connections are deleted
first, then, if you press DEL again, the
horizontal connections are deleted.
-------- [ Q 01
L: 1 C:1 B:7944