Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 145)

Publication 2364F-5.01– October 2003
Appendix
D
Programming Parameters
This appendix lists the programming parameters for the RGU.
32
Host Command Word
[Host Command]
This parameter commands the processor to
perform the function(s) indicated by each fault bit
which is set to 1.
For example, to command the processor to clear
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0000 0000 0000 0000
Minimum Value 0000 0000 0000 0000
Maximum Value 0000 1111 1111 1111
Related Parameters P33, P34, P35
faults, you would enter the command word, 0000
0000 0000 0001.
Bit Description
0 Clr Faults Sends a command to clear faults in the RGU
1 Enable Cmd Sends a command to Enable RGU control
2 Meter Reset Sends a command to reset the watt-hour meter
3 Save Command Sends a command to save parameters
4 Param Recall Sends a command to reset parameters
5 Default Init Sends a command to initialize parameters to their defaults
6 Clr Warnings Sends a command to clear warnings in the RGU
7 Reset Cmd Sends a command to reset the RGU
8 Clr Flt Que Sends a command to clear the fault queue
9 Clr Wrn Que Sends a command to clear the warning queue
10 Disable Cmd Sends a command to Disable the RGU control
11 Run Startup Sends a command to reset the RGU and to initiate the startup sequence
12-15 Not Used
Bit
8
Bit
9
Bit
10 Bit
11 Bit
12 Bit
13 Bit
14 Bit
15 Bit
0
Bit
1
Bit
2
Bit
3
Bit
4
Bit
5
Bit
6
Bit
7
A Parameter Number
B Parameter Name
C Screen Text
This indicates the name shown on the display.
D Parameter Description
This describes the parameter’s function and its relationship with other
parameters. This may include diagrams and programming examples.
E Bit Number
For parameters displayed as words, the bits are displayed on the screen
from 15 to 0. Each bit can be set separately (if read/write parameter).
F Bit Name
This indicates the bit name shown on the display screen.
G Bit Description
This describes the function of the bit end may show its relationship
with other parameters or conditions.
H Parameter Specifications
These fields indicate parameter attributes.
Parameter Type Indicates whether the parameter is a source or
sink, and whether it is read/write or read only.
Indicates the units shown on the display (i.e. %,
Volts, uH).
Indicates the conversion formula for internal units.
For example, if the drive units are equal to
‘Display Units x 5120/100’, a value of 15 on the
display would be stored as 768 (15 x 5120/100)
internally.
Indicates the default value for this parameter.
Indicates the minimum value allowed.
Indicates the maximum value allowed.
Lists other parameters that are related in some
Display Units
Drive Units
Factory Default
way to this parameter.
Minimum Value
Maximum Value
Related Parameters
A
B
C
D
E
F G
H