Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 193)

Publication 2364F-5.01– October 2003
Programming Parameters D-49
253
SCANport Remote Data In: B1
[Rem Data In:B1]
This parameter shows the value of datalink B1
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
254
SCANport Remote Data In: B2
[Rem Data In:B2]
This parameter shows the value of datalink B2
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
255
SCANport Remote Data In: C1
[Rem Data In:C1]
This parameter shows the value of datalink C1
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
256
SCANport Remote Data In: C2
[Rem Data In:C2]
This parameter shows the value of datalink C2
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
257
SCANport Remote Data In: D1
[Rem Data In:D1]
This parameter shows the value of datalink D1
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
258
SCANport Remote Data In: D2
[Rem Data In:D2]
This parameter shows the value of datalink D2
which is being received from a SCANport device.
This value may be used by linking other
parameters to this parameter.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251, P259
259
SCANport Remote Data Out: A1
[Rem Data Out:A1]
This parameter shows the value of datalink A1
which is being passed to a SCANport device.
Link this parameter to the parameter that is to be
passed through datalink A1.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P251