Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 210)

Publication 2364F-5.01– October 2003
D-66 Programming Parameters
414
Signal Processor 3 Gain
[SigProc 3 Gain]
This parameter specifies the gain that should be
applied to the source value (indicated in P412).
Note that the offset is applied before the gain.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 1.00
Minimum Value -4.00
Maximum Value 4.00
Related Parameters P412 to P416
415
Signal Processor 3 Offset
[SigProc 3 Offset]
This parameter specifies the offset to apply to the
source value (indicated in P412).
Note that the offset is applied before the gain.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0
Minimum Value -32768
Maximum Value 32767
Related Parameters P412 to P416
416
Signal Processor 3 Cutoff Frequency
[SigProc 3 Cutoff]
This parameter specifies the cutoff frequency to
be used by the signal processor.
Parameter Type Source (Read Only)
Display Units R/S (rad/sec)
Drive Units Display Units * 1
Factory Default 0
Minimum Value -32768
Maximum Value 32767
Related Parameters P412 to P415