Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 207)

Publication 2364F-5.01– October 2003
Programming Parameters D-63
337
Trend 4 Mode
[Trend Mode]
This parameter determines the duration of the
trending process. The trending process can be
configured to stop trending after a trigger event
occurs (default), or can continue trending.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0
Minimum Value 0
Maximum Value 1
Related Parameters P329 to 340 (See also P298)
Value Description
0 One ShotCommands the trending process to stop after a single trigger event.
1 ContinuousCommands the trending process to run continuously.
338
Trend 4 Select
[Trend Select]
This parameter commands the RGU to enable,
disable, or force trigger Trend 4.
After the RGU processes the command, the value
resets to 3 (No Command).
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 3 (No Command)
Minimum Value 0
Maximum Value 3
Related Parameters P329 to 340 (See also P298)
Value Description
0 DisableCommands the RGU to disable Trend 4.
1 EnableCommands the RGU to enable Trend 4.
2 Force TrigCommands the RGU to force trigger Trend 4. The trending value (prescribed by P329) will be sent to Trend 4 Output Indirect (P340).
3 No CommandIndicates that no command is issued at this time.
339
Trend 4 Status
[Trend Status]
This parameter displays the status of Trend 4.
Parameter Type Sink (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 1 (Unprogrammed)
Minimum Value 0
Maximum Value 4
Related Parameters P329 to 340 (See also P298)
Value Description
0 UnprogrammedTrend 4 is not programmed.
1 StoppedThe trending operation is stopped (trend X and trend Y values are not being evaluated).
2 RunningThe trending operation is running (trend X and trend Y values are being evaluated).
3 TriggeredThe trending operation between trend X and trend Y is true. The trending value (determined by P329) will be output through P340.
4 Forced TrigTrend 4 is triggered due to a ‘Force Trig’ command from the Trend 4 Select (P338 = 0). The trending value is output.
340
Trend 4 Output Indirect
[Trend Out Ind]
This parameter prescribes the destination of the
trend parameter value (listed in P329). The
trending operation (X [operator] Y) must be
evaluated as true for P340 to output the value
from the trend source in P329.
Parameter Type Sink (Read/Write)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 0 (no selection)
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P329 to 339 (See also P298)
341
Number of Trend Samples
[Trend Samples]
This parameter indicates the number of trend
samples taken (up to 500).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 500
Minimum Value 0
Maximum Value 500
Related Parameters P298, P300