Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 73)

Publication 2364F-5.01– October 2003
Installing Your RGU 7-3
Installation Procedure
1. Verify that the RGU has no mechanical damage. If you notice any
damage, refer to the section Drive System Receiving in the
Preface of this manual.
2.
Note: Do not splice the RGU’s common DC bus to the lineup at
this time.
3. Verify that the disconnect is open at this time.
!
ATTENTION: To avoid the hazard of electrical shock,
verify that all voltages on the system bus network have
been discharged before attempting to service the
system.
ATTENTION: Be sure to obey all local electrical
codes when installing your drive system. This
installation procedure provides guidelines that can be
used in the case that codes do not exist.
If your drive system is
packaged in:
Position and secure the RGU enclosure to the
remainder of the drive lineup according to the
installation practices of publications:
Bulletin 2300 or Bulletin
2100 enclosures 2100-5.5 Receiving, Handling, and Storing Motor Control
Centers–Instructions
2300-5.1 Bulletin 2300 Family of Drive Systems Hardware–
Installation Manual
FD86N enclosures 2100-5.5 Receiving, Handling, and Storing Motor Control
Centers–Instructions
S-3062 FD86N Enclosure Hardware–Installation Manual